Protocol Cfg - Selecting this option will cause Iniquity to load up the internal PROTOCOL editor. This will allow you to add, edit, or delete any transfer protocol. User Editor - Selecting this option will cause Iniquity to load up the internal USER editor. This will allow you to edit, or delete a user account. When you edit an account, you have the ability to place several restrictions on a user, or remove them, and therefore showing the user that they must be careful about what they do. Launch Menu - Selecting this option will cause Iniquity to jump right into the menu you choose to load up, you will be prompted for the name. When you have completed you session you must log off normally. The account used when loading up the menu is the SysOp's account. Read Email - Selecting this option will cause Iniquity to display a list of all the current EMAIL messages sent to you, from here you can select where you want to begin reading messages. View Mailbox - Selecting this option will cause Iniquity to display a list of all the current EMAIL messages sent to a user, you will be prompted for the user's name. Enter Email - Selecting this option will allow you to enter an EMAIL message to a user, sending the message is the same as sending EMAIL through the board. Filearea Editor - Selecting this option will cause Iniquity to load up the internal FILE AREA editor. This option works much the same way as the message base editor, but this editor deals with file bases, not message bases. Edit Textfile - Selecting this option will cause Iniquity to load up the full screen editor, allowing you to edit the file you were prompted for.