By Selecting option [K] Iniquity will display q screen similar to the
 one below. On the screen is a list of options that will allow you to
 configure all settings dealing with swapping. Swapping is where variables
 that are stored in memory are moved to a new location to make room for more
 information. There are two areas that can be used for swap space, EMS memory
 or your hard drive, depending on where you have the most space. If you have
 selected EMS memory, then Iniquity will look for the correct amount of space
 in EMS memory first, if there isn't enough space then Iniquity will store the
 swap file on the hard drive.

  ______________________________________________________________________________
  \_________    .   __________    .    __    |   ________        __    .   ___/
   //     \     :    \     \\     |    \     :    \     \\       \     :    \ jp
__/        \    |     \      \    :    \\    .     \      \       \    |    \\
 \_________/____|     //_____/_____    _/__________/______/_______/___ '     /
  [iniquity2.0] |____/ ========= /__________/ =============== \\____________/
    (Memory Usage and Swapping Setup)::::::::::::::::::::::::::::::: 
 (a) Load overlay to XMS                No
 (b) Load overlay to EMS                Yes
 (c) Swap when shelling                 Yes
 (d) Use EMS for swapping               No
 (e) Use XMS for swapping               Yes
 (f) Use EXT for swapping               No
 (g) Protocol swapping                  Yes
 (h) Archiver swapping                  Yes
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
À: iq config % arrows: move lightbar   enter/key: select   escape: quit menu :Ù


   [A] Load Overlay to XMS  - This option allows you to toggle if iniquity
                              will load overlay file into extended memory
                              if it is available, otherwise it will use
                              EMS/Disk.

   [B] Load Overlay to EMS  - This option allows you to toggle if iniquity
                              will load overlay file into expanded memory
                              if it is available otherwise it will use disk.
   
   [C] Swap When Shelling   - This option allows you to toggle Iniquity's     
                              ability to swap to memory when you are shelling 
                              to DOS.

   [D] Use EMS For Swapping - This option allows you to toggle Iniquity's use 
                              of EMS memory or the use of the hard drive when 
                              swapping to memory.

   [E] Use XMS For Swapping - This option allows you to toggle Iniquity's use
                              of XMS membory or the use of the hard drive when
                              swapping to memory.

   [F] Use EXT For Swapping - This option allows you to toggle Iniquity's use
                              of plain EXT memory(INT 15h) for swapping or the
                              use of the hard drive when swapping to memory.

   [G] Protocol Swapping    - This option allows you to toggle Iniquity's
                              ability to swap to memory when a user is
                              downloading, or uploading, a file.

   [H] Archiver Swapping    - This option allows you to toggle Iniquity's     
                              ability to swap to memory when a user has caused 
                              Iniquity to compress or decompress a file.